Charging new Drill batteries can be frustrating. Most people have been told that they should charge their new battery before using it. Some of you already know that trying to charge the battery first does not always work. Depending on how long the battery has been sitting on the shelf is directly related to how much energy is left in the battery pack. Batteries are not shipped fully charged, but they do get an initial charge from the factory to energize the cells and test the integrity of the pack. If you receive a new or recently built battery pack, your charger may not recognize that the battery needs to be charged. Some chargers, sample the voltage of a battery pack to determine whether or not the pack needs charging and if it see the voltage where it should be like in the case of a freshly manufactured battery pack, it will not start to charge. The charger believes the battery is already at full charge and does nothing or it may light up momentarily and the stop. What is needed is to put the pack into the drill and run it down a little and then try putting it back into the charger. If the charger still will not charge the battery, then you may have a defective charger, but try this first.
Ron. Drill Batteries
2 comments:
I have a question, I have a Makita 14 volt cordless drill battery and I wish to rebuild it. but I don't know how to get the case apart, I don't see any screws, it looks like it is sealed...any ideas..anyone. thanks
I have tried a couple of ways to get these types of packs open. The first was using a fine hacksaw blade and cut around the seam, but that took away too much material. The second was using an exacto knife and very carefully making three passes around the seam not to cut myself and opening it up. The second way is obviously more dangerous, but if you take your time and use some precautions like a vise to hold the pack, then you are not taking away any material, just displacing it and can then be glued back together.
Post a Comment